It will then look like this.You can find out more about which cookies we are using or switch them off in settings.
![3dlabprint bowden 3dlabprint bowden](https://3dlabprint.com/wp-content/uploads/2018/08/Front-internal.jpg)
Normally cura would print solid infill to help the lines in the first image hold together. In the last one I halved the layer height again and you can see that the lines are fusing to each other, supporting each other. In the 3rd image from the left I've halved the layer height, the lines are close together, almost touching but there's still tiny gaps which would lead to the same problem you're having. As you can see, every individual line is hanging in the air, it has no support from previous layers. The first layer view is with a fairly thick layer height 0. I used a simple cube as an example and tilted it to get a similar angle as you have in your model. What is your bed and hotend temperature at. Here is a guide from simplifiy 3D You can look at.
![3dlabprint bowden 3dlabprint bowden](https://3dlabprint.com/wp-content/uploads/2018/08/View4.jpg)
Oh also check that the size of your filament it's really 2. If there's really something wrong there it will be easier to debug it. Also, just incase, what cura version are you using? Because if you use the new cura and statt to adjust Coasting, then you can get an effect like that if too high, but that would show on all the layers.Īnd from there start to adjust stuff. You should check layer by layer the cura preview and see if it's printing on the air, or there's any error on the stl. The previous layer isn't providing any support for the next layer so it just floats in the air. That's simply that the layer height is too high for the angle at that particular part of the print. Those problems have nothing to do with retractions.
![3dlabprint bowden 3dlabprint bowden](https://www.3dpmav.com/wp-content/uploads/2019/06/phonepic-5217.jpg)
Does anyone know where I would make these changes, either in cura or ultimaker settings? I'd like to see if these make things better, or allow me to increase the speed with out reducing strength.Įven with my current settings when printing steep angles there are some slight weaknesses between layers. The 3dlabprint guide states the following. Hi, I'm printing one of the 3dlabprint planes, which is mostly hollow with some support structures. By chrismrutherfordJuly 26, in Ultimaker 3D printers.